Silk PLA printing problems.

[Andre]

Hello Folks,

I have used quite of few settings in order to make the silk PLA I got off Amazon to work. I have test tree frogs all over the...

[coderforlife]

If the customizer setup behind MakeWithTech available as open source? I understand that it likely uses OpenSCAD at the core, but just parsing a scad file...

[jderienzo]

has anyone reviewed this upgrade for Prusa MK3? https://prorifi3d.com/collections/up...41879317708991

[Pigjes]

I am all for saving plastic waste. But the new type of raft and brim in the 2.5 does not work well anymore, as they are too minimal. I print a lot of...

[Larry Hootman]

RE: Need help with Prusaslicer 2.5 error
I have been using my Ender 3 v2 for about 6 months now and have used up my first 1 kg reel of filament....

[tewkes]

Hi everyone,

Just wondering if anyone has encountered the attached card read error, which I am getting after selecting a gcode file and...

[Larry Bowers]

Hello All,

Got a question about updating firmware on my Ender 3 Pro running a 4.2.2 (non silent) board to the 4.2.7 silent board.
...

[Larry Bowers]

Got a question for you guys,

I'm working on a project in Freecad 0.21 and will eventually bring in into Cura to print.

As...

[irvshapiro]

Folks,

I have a favor to ask. In the next couple of weeks, I will be releasing a new home page on the models.makewithtech.com site. This...

[BSKFeralLycan]

So I came across this printer " IdeaFormer-3D IR3 VV" on social media ( https://www.tiktok.com/t/ZTR55ucwj/ ) and seen it available on Amazon...