Not slicing the full model

Hey All, brand new to this, but purchased an MP10, installed their recommended version of Cura 4.0, uploaded the Gcodes and recommended settings. The issue I’m having is when I slice it and it shows to total time to make, say 2 hrs, but when I go to print, it’s only printing the bottom layer and/or middle layer. I’m completely lost on this one.

Hmmmm, my first thought was, “How is it printing a middle layer without a bottom layer?”

Let me rephrase, its only printing the bottom layer

Rename the file your trying to slice to so it has an extension of txt and attach it to a message so we can take a look at it and see it it will slice correctly.

In the slicer after you slice it you can preview it and even look at it layer by layer if you see the full file there it should print the full file and not just the 1st layer. Also Cura 4.0 is a pretty old version the current version is 5.2.x UltiMaker Cura: Powerful, easy-to-use 3D printing software