Has anyone upgraded their creality ender 3 max neo to a sprite extruder and if so how did u get the CR touch to calibrate to the bed mine seems to be trying to auto level like 2 1/2 inches off the front of the bed

General
, , , ,
1

Has anyone upgraded their creality ender 3 max neo to a sprite extruder and if so how did u get the CR touch to calibrate to the bed mine seems to be trying to auto level like 2 1/2 inches off the front of the bed not quiet sure how to change the bed size to get it to land on the bed…

2

Don’t have a MAX but it sounds like the CR Touch is mounted in a different place than with the other extruder. So you will need to set the X-Y offset for the Sprit extruder. Not sure if this can be done in the menu or not on Crality firmware.

3

not familiar with your setup but when this happens to me w my Ender 5+ w BL touch, it’s b/c the BL touch probe is not extended downward and is retracted.
hope this helps.
if you turn off and on, and the probe doesn’t fall, try another probe.