A few months back I intimated that I was working on my own Lithophane display stand. I've gone through a few designs, but today I'm going to present the 2 main ones.
Here's Rev1

The face is blurred because I don't have permission to post it.
The push-button switch is an interesting story. I tried to find some simply push-on push-off type push-button switches on Amazon but could only find momentary type, at least ones that would suit my purpose. So, I ordered some tiny push-on push-off and resigned myself to having to design & print a switch housing.
It may be a little overkill, but the LEDs do produce a little heat, so I decided to 1st stick the LEDs to the back wall of the light frame using the supplied 3M adhesive, then hot blue the edges down.
I also ordered a pack of female Micro USB connector boards to provide power to the LEDs.
Here's Rev1
The face is blurred because I don't have permission to post it.
The push-button switch is an interesting story. I tried to find some simply push-on push-off type push-button switches on Amazon but could only find momentary type, at least ones that would suit my purpose. So, I ordered some tiny push-on push-off and resigned myself to having to design & print a switch housing.
It may be a little overkill, but the LEDs do produce a little heat, so I decided to 1st stick the LEDs to the back wall of the light frame using the supplied 3M adhesive, then hot blue the edges down.
I also ordered a pack of female Micro USB connector boards to provide power to the LEDs.
Comment