I got a Raspberry Pi 4 for my Octoprint. I have had good luck with the Miuzei case, so I decided to get another one for this mission:

It has the two x-shaped notches cut out of the bottom plate for hanging, so I got out my calipers and measured it up for designing my own bracket:

The FreeCAD file and STL file are attached in the ZIP if you are interested. Everything (except the fillet sizes) is parametric with the design using a FreeCAD spreadsheet.
I used supports for the print:

More in the next post...
It has the two x-shaped notches cut out of the bottom plate for hanging, so I got out my calipers and measured it up for designing my own bracket:
The FreeCAD file and STL file are attached in the ZIP if you are interested. Everything (except the fillet sizes) is parametric with the design using a FreeCAD spreadsheet.
I used supports for the print:
More in the next post...
Comment