Hi,
I am very new to 3d printing. My ender 3 pro arrived a few days ago, printed the benchy pretty good in blue. Had some issues with the black (clogged the bowden tube), Both these prints seemed to fail at the 2.5 hour mark.


after cleaning the end of the bowden tube seemed to be ok. Printed some things in blue without issues. I dont know if the black (same brand) caused the issue, or the longer print time.
I then printed this Sonic 75mm with Cura with Cheps Best profile setting - 9 hours.
https://www.youtube.com/watch?v=TuLNXPsjEOo
Since this I have worked on adjusting my retraction, and esteps. I need to calibrate flow rate and I think I might work on calibrating a bit more before trying longer prints.
I am very new to 3d printing. My ender 3 pro arrived a few days ago, printed the benchy pretty good in blue. Had some issues with the black (clogged the bowden tube), Both these prints seemed to fail at the 2.5 hour mark.
after cleaning the end of the bowden tube seemed to be ok. Printed some things in blue without issues. I dont know if the black (same brand) caused the issue, or the longer print time.
I then printed this Sonic 75mm with Cura with Cheps Best profile setting - 9 hours.
https://www.youtube.com/watch?v=TuLNXPsjEOo
Since this I have worked on adjusting my retraction, and esteps. I need to calibrate flow rate and I think I might work on calibrating a bit more before trying longer prints.
Comment