Announcement

Collapse
No announcement yet.

Strain Relief on Ender 5 Plus

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Strain Relief on Ender 5 Plus

    I recently found a Hot End strain relief for the ender 5 series on thingiverse and modified it slightly to incorporate support for the Bowden tube as it enters the Hot End. I then used tinkercad to design a simple support to attach to the 20 x 20 extrusion just above the extruder to offer support tot he bowden tube. I had noticed that at times the bowden tube could sag down a bit, it never caused a problem but I think it looks better supported and I hope avoids any snag issues in the future.

  • #2
    A nice, simple solution. Good on you mate (and Go The Rabbitohs 😎)

    Comment

    Working...
    X