Announcement

Collapse
No announcement yet.

Artist-D Pro and Octoprint

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Artist-D Pro and Octoprint

    I want to get Octoprint setup with my Artist-D Pro but have not gotten it to work properly. I can receive the information from the printer but have been unable to send prints to the printer. Any suggestions?

  • #2
    What does the output in the Terminal tab look like?

    Cheers

    EDIT: Can you copy and post the information in the Terminal tab so we can see the connection information and what the printer isn't responding to?
    Alan
    Senior Member
    Last edited by Alan; 11-18-2021, 09:39 PM.

    Comment


    • mac1281
      mac1281
      New Member
      mac1281 commented
      Editing a comment
      I am sorry for the delay in response. I had to return my previous printer and got a replacement. The new one had a newer firmware from JGMaker and started working immediately with OctoPrint.

      Thank you.

  • #3
    When you say you can "receive the information from the printer" do you mean the information in the terminal window is legible, not gobbledy-gook? If so, that would rule out the possibility that you have the wrong BAUD rate.

    Comment


    • mac1281
      mac1281
      New Member
      mac1281 commented
      Editing a comment
      I apologize for the delay in response. I was able to see the temperatures and terminal code. Once everything was up to temp then the printer would shut down. I had an issue with the printer and had to get a replacement, when I got the new printer I noticed it was running a newer firmware and Octoprint started working.

      Thank you
Working...
X