Hi all,
I've installed a BigTreeTech Smart Filament Sensor on my Ender 3 V2 (with Marlin fw) & Octoprint. I followed the fantastic DrVax video on a similar topic (Octoprint Multicolor 3d Prints including Ender 3 V2 - https://www.youtube.com/watch?v=P8Q3RmZWNzg&t=2s).
After all config, eveything seems working fine, except that after pressing "resume" in Octoprint, my Ender 3V2 seems to come back only at the right position of X&Y axes, but not for Z! So it starts to extrude in the air... 😓
I'm using Cura 4.8 and I already copied&Pasted "Pause" & "Resume" codes in the related boxes within Cura as specified by DrVax.
I'm becoming crazy.... I ran several tests without finding any solution....
Do you have any suggestion on how to solve this issue?
Many thanks in advance to anyone will give me some tips!
Kind regards,
Stefano
I've installed a BigTreeTech Smart Filament Sensor on my Ender 3 V2 (with Marlin fw) & Octoprint. I followed the fantastic DrVax video on a similar topic (Octoprint Multicolor 3d Prints including Ender 3 V2 - https://www.youtube.com/watch?v=P8Q3RmZWNzg&t=2s).
After all config, eveything seems working fine, except that after pressing "resume" in Octoprint, my Ender 3V2 seems to come back only at the right position of X&Y axes, but not for Z! So it starts to extrude in the air... 😓
I'm using Cura 4.8 and I already copied&Pasted "Pause" & "Resume" codes in the related boxes within Cura as specified by DrVax.
I'm becoming crazy.... I ran several tests without finding any solution....
Do you have any suggestion on how to solve this issue?
Many thanks in advance to anyone will give me some tips!
Kind regards,
Stefano
Comment