Welcome to the MakeWithTech Community (formerly DrVax).
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I am excited to announce a new benefit for forum viewers. The first "Live Behind the Scenes" video covering the Fokoos Odin-5 F3 is available. I will post these videos, on the forum, days to weeks before I release a new video. Here is a link to this first video:
What results have you obtained using this tool (I wish the site let you add start and end gcode, like TeachingTech's site)? I tried it and the results were ambiguous. It might be my printers tho.
Tweet
Comment