iam facing a problem in printing lithophane always it turns to under extrusion ONLY in one side of the print.
I am using ender 5, calibrated XYZ and E with TLsmoother on XY and E. The machine is very sharp in everything I print like Cal cubes and all torture test's but when it comes to litho It always act stupid with no reason.
Here's some pictures to analyse
*Material

*Noz temp 210
*noz dia 0.4
*line width 0.4,0.38
*Bed tmp 60-50
*Brim
*Printing spd 42
*Retract yes 5
*6 wall -0 infill / 2wall -100% infill / 2wall-99%infill ( tried all this combinations)
*Optimise wall printing order YES
Cura 4.5/4.6/4.7.1 (4.5 gives the better result to compare with other versions but still had the same problem)
Also there's a picture from what does it look like from behind
Comment