With the umbrella brackets out of the way, I moved on to a pet peeve of ours: the vacuum cleaner floor brush always interfering with putting the vacuum back into its closet. I designed and printed a couple of small hangers that will hold the brush out of the way, but still available when needed.
Here's a photo of the closet as it was. If you look closely, you can see the floor brush tucked away at the rear of the closet.

Here, you can see the 2 hangers, mounted with 3M Command Strips on the back wall of the closet.

And here's the floor brush resting comfortably in its new abode.

The hangers are not quite as simple as they look. They actually slide down on a 'clip' I designed & printed.

The recesses in the hangers are angled to match chamfers on the ends of both clips.
Here's a photo of the closet as it was. If you look closely, you can see the floor brush tucked away at the rear of the closet.
Here, you can see the 2 hangers, mounted with 3M Command Strips on the back wall of the closet.
And here's the floor brush resting comfortably in its new abode.
The hangers are not quite as simple as they look. They actually slide down on a 'clip' I designed & printed.
The recesses in the hangers are angled to match chamfers on the ends of both clips.
Comment