Announcement

Collapse
No announcement yet.

Cura V5 with experimental variable z height.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Cura V5 with experimental variable z height.


    My sisters son wanted a ShyGuy mask (Nintendo IP from the Mario universe) for a theme party.

    Since the mask is dome shaped and domes usually look awful, when printed with 0.2 or lower resolution, I tried the latest feature in Cura and it worked awesome.

    Basically this new feature increases the layer height depending on the model. Yes, you could do change the layer height at any position using per layer settings changes, but this is different. It changes the layer height depending on the z shape and and layer, which is awesome.

    The 0.2 print time was about 12 hours. With enabled adaptive layer feature it added about 30 minutes, but the resulting surface looks stunning. If I would have used 0.1 all the way up, it would have nearly doubled the print time and it wouldn´t look as good for sure as this is dynamically changing the height per layer. I used 0.1mm as maximum deviation and 0.01mm as step size. I think both were defaults for adaptive layer height anyway.

    I posted a make on thingiverse and as you can see on the image only the small section between the eyes is rough, which is also the highest section of the mask. The rest probably does not even need sanding. I never saw a 3d printed round shape that smooth without sanding.

    Click image for larger version  Name:	ShyGuyMask_1.jpg Views:	1 Size:	115.4 KB ID:	15409

    https://www.thingiverse.com/make:1037639

    I printed the mask in ABS to give it a little flex.

    So If you need a round shape, give the "adaptive layer height" (back translated as I only see German texts) within the experimental section a chance. The top section was not perfect, but the rest was stunning!
    Last edited by Geit; 06-04-2022, 04:49 PM.

  • #2
    Holy cow I agree I have never seen an oval print that smooth. Even zoomed in it was hard to see the layer lines except for the one spot between the eyes.

    Comment


    • #3
      Amazing! I was going to wait a bit to try V5. Going to install today!

      Comment


      • #4
        Nice job Geit. Your nephew should love it. The Adaptive Layer Height feature is impressive. Now, if they can correct the other issues people are having it will be a major step forward. Congrats.

        Comment


        • #5
          Originally posted by Gramps View Post
          Holy cow I agree I have never seen an oval print that smooth. Even zoomed in it was hard to see the layer lines except for the one spot between the eyes.
          I guess I should have set the minimum layer time properly, to prevent the issues at the top.

          Comment

          Working...
          X