I own an Anet ET4. It does not print square. I have attached a photo of the bottom layers of a square box I started to print. Clearly it is not square. I would like some suggestions on how to correct this. SIMPLE is BEST.
I have looked at using some math and an XYZ calibration piece to correct this. Not sure this is the way to go. Also, when I measure the XYZ calibration piece with a digital calliper I get different results. The tiniest shift in pressure kicks out different numbers. All thumbs.
I have looked at using some math and an XYZ calibration piece to correct this. Not sure this is the way to go. Also, when I measure the XYZ calibration piece with a digital calliper I get different results. The tiniest shift in pressure kicks out different numbers. All thumbs.
Comment