When I tried to slice the 20mm X 20mm X 1 layer prints that I always use to confirm good bed leveling and nozzle height, it would not slice. I checked again in 4.10.0 and it sliced just fine.
I reported the issue on github. A guy named Mark Burton responded to my report and, after a couple of messages back and forth, he confirmed that it is an issue and has already been reported. Thank you Mark.
So, to anyone who also uses the 1 layer squares, take note.
I reported the issue on github. A guy named Mark Burton responded to my report and, after a couple of messages back and forth, he confirmed that it is an issue and has already been reported. Thank you Mark.
So, to anyone who also uses the 1 layer squares, take note.
Comment