No announcement yet.

Ender 3 Max-Homing Failed after BL Touch install

  • Filter
  • Time
  • Show
Clear All
new posts

  • Ender 3 Max-Homing Failed after BL Touch install

    Hello everyone. I'm new to the forum but have been watching Dr Vax on YouTube for a long time. I recently purchased an Ender 3 Max after owning a Tevo Tornado for over 2 years. I'm having more challenges with the Ender than I expected. The stock glass bed is higher in the center and makes it impossible to level manually. I was sent a replacement but it has the same issue. To compensate I got a BL Touch and installed it. I don't have one of these for my Tornado but I watched videos on installation and had no problems. However, sometimes, not always, I'll get a "Homing Failed Please Reset" error. I figure out why, especially when it doesn't always happen. Maybe an issue with the firmware that I got from the Creality website? I appreciate any insight. Thank you.

  • #2
    Had the same issue with BLTouch on an Ender 3 v2 my glass bed isn't flat either. Had 2 BLT's and issues with both of them finally gave up and bought a EZABL from TH3DStudio have had no issues with it.

    Make sure that your BLT is perpendicular to the bed if not will cause issues.


    • #3
      I'm having the same issue with the Ender-3 Max and BLT. I may have to try the EZABL.